Supported Parameter Types/Vectors

Vectors can be used as console parameters, by typing in the axis components directly into the console, or by typing one of the standard vectors such as 'up' or 'right'

Vector2

Vector2 parameters are entered by entering comma-delimited x and y values, for example

25.3,34

Will give a vector with x=25.3 and y=34.0.

 ! Note that there cannot be spaces in the vector definition, the Reflex Console will interpret this as a new parameter.

The following named presets are defined for Vector2 parameters and will be shown as suggestions:

• zero
• one
• down
• left
• right

Vector3

Vector2 parameters are entered by entering comma-delimited x and y values, for example

25.3,34,42.872

Will give a vector with x=25.3, y=34.0 & z=42.872

 ! Note that there cannot be spaces in the vector definition, the Reflex Console will interpret this as a new parameter.

The following named presets are defined for Vector2 parameters and will be shown as suggestions:

• zero
• one
• forward
• back
• down
• left
• right
• fwd